EGW red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install. Simply remove the rear sight on your gun and replace it with the mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take the mount off and replace your rear sight at any time. Mounting hardware included. Installation Instructions Remove the rear sight* Install the EGW Sight Mount in the dovetail Tighten set screw (if applicable) Place the red dot sight on the EGW Sight Mount (placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.) Apply blue Loctite to the provided mounting screws Torque mounting screws to 15in/lbs 2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights 2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights The screws that are included with this mount require a 5/64'' allen wrench for installation. Modification of your firearm may nullify the manufacturer's warranty. This product should be installed and checked by a qualified gunsmith. No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Mejora tu puntería con el montura EGW para Vortex Viper/Venom.
La montura EGW para los modelos TAURUS G2, G3, PT709 y TX22 está diseñada para facilitar la instalación de tus miras rojas Vortex Viper/Venom, Burris FastFire o Docter. Con un diseño que permite una instalación sencilla, podrás mejorar tu experiencia de tiro en poco tiempo.
Descripción del producto
Las miras rojas de EGW están pensadas para ser instaladas de izquierda a derecha (con el cañón apuntando hacia adelante). La base tiene un ángulo progresivo que facilita la instalación. Simplemente retira la mira trasera de tu arma y reemplázala con la montura para montar tu mira roja.
Instrucciones de instalación
- Retira la mira trasera*
- Instala la montura EGW en la base de la mira
- Ajusta el tornillo de fijación (si es aplicable)
- Coloca la mira roja sobre la montura EGW (colocar un pequeño trozo de papel entre la mira roja y la montura facilitará su remoción y evitará que el Loctite se adhiera a la mira roja).
- Aplica Loctite azul a los tornillos de montaje proporcionados
- Ajusta los tornillos de montaje a 15in/lbs
Incluye:
- 2 Tornillos de cabeza de botón - Proporcionados para las miras Vortex Viper y Venom
- 2 Tornillos de cabeza plana - Proporcionados para las miras Burris FastFire y Docter
Los tornillos incluidos con esta montura requieren una llave allen de 5/64'' para la instalación. Ten en cuenta que la modificación de tu arma puede anular la garantía del fabricante.
Este producto debe ser instalado y revisado por un armero calificado. No se asume ninguna responsabilidad por daños o lesiones que puedan resultar de una instalación o uso inadecuado de este producto.